#1 22. November 2006 kann mir jemand sagen ob es mit der Intel PRO 3945ABGWireless problem gibt bezüglich SuSe 10.1 ? Das wär mir ganz arg wichtig, weil früher hatte ich die alte Intel Pro Wlan weiß nicht mehr wie die hieß 2XXX und die wurde nicht erkannt, gabs auch keine vernünftigen Treiber etc. sprich hat jemand die Konfiguration? Ich denke mal ganz bestimmt oder, dürfte ja nicht unüblich sein. würde das wieder nicht funktionieren spar ich mir die ganze arbeit mit installieren... google gibt auch nichts her. + Multi-Zitat Zitieren
#2 23. November 2006 AW: SuSe 10.1 Prob mit Intel WLAN 3945ABG Hallo, folgendes habe ich gefunden. Ich hoffe das hilft Dir! Code: The following is a step-by-step instruction on how to get your Intel 3945abg wireless card configured in SuSE 10.0. Step 1: Download ieee80211 version 1.1.11 (version 1.1.12 may also work, but I haven't tried). DO NOT USE VERSION 1.1.13 - IT WILL NOT WORK WITH INTEL'S 1.0.0 STABLE DRIVERS!!! You can get the file here: http://ieee80211.sourceforge.net/#downloads Step 2: Untar, compile, and install the ieee80211 by running the following commands. Note, if it prompts you to remove old versions of ieee80211, select yes. # tar xvzf ieee80211-1.1.11.tgz # cd ieee80211-1.1.11 # make # make install Step 3: Download the Intel 1.0.0 stable drivers here: http://downloadfinder.intel.com/scripts-df-external/detail_desc.aspx?ProductID=2259&DwnldID=10315&agr=Y Step 4: Untar the file with the command: # tar xvzf ipw3945-linux-1.0.0.tgz # cd intel-ipw3945-1.0.0[/b] Step 5: After you untar the file, there will be 3 additional tar files: the intel driver, the microcode, and the regulartory deamon. Install the microcode by typing the following: # tar xvzf ipw3945-ucode-1.13.tgz # cp ipw3945-ucode-1.13/ipw3945.ucode /lib/firmware/ Step 6:: Install the regulartory deamon by typing: # tar xvzf ipw3945d-1.7.18.tgz # cp ipw3945d-1.7.18/x86/ipw3945d /sbin/ or, if you have an 64bit cpu: # cp ipw3945d-1.7.18/x86_64/ipw3945d /sbin/ Step 7: Now compile and install the Intel drivers. # tar xvzf ipw3945-1.0.0.tgz # cd ipw3945-1.0.0 # make # cp ipw3945.ko /lib/modules/$(uname -r) # depmod -a Step 7: Configure to auto launch the regulartory deamon and Intel module by add the following your /etc/modprobe.conf.local file: install ipw3945 /sbin/modprobe --ignore-install ipw3945 ; sleep 0.5 ; /sbin/ipw3945d --quiet Step 8: Restart your computer and the module will automaticaly load. You can verify everything is working by typing: # iwconfig You should see your list of wireless network interfaces like this: lo no wireless extensions. eth0 no wireless extensions. eth1 unassociated ESSID:off/any Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00 Bit Rate=0 kb/s Tx-Power:16 dBm Retry limit:15 RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:1388 Missed beacon:0 Hope this helps other people! Now, the only thing I have left to do is configure the wireless card to use WPA. I'm also having trouble where YAST doesn't recognize the card as a wireless card. I'll work this later - I have to get back to work before I get fired. Additional info, if you wish to have encryption with WPA enabled, be sure to install the wpa_supplicant package via YAST. Reconfigure your wireless card and you should be set. BTW - in my post above, I forgot to mention you may have to reconfigure your your new wirless card via YAST and change the device type for "Ehternet" to "Wireless" in order to have the ability to set wireless encryption, etc. onlinepilot + Multi-Zitat Zitieren
#3 23. November 2006 AW: SuSe 10.1 Prob mit Intel WLAN 3945ABG vielmals danke... wo hast du das gefunden ? bzw. da steht ja das der hinweis für yast noch kommt wegen der verschlüsselung. aber das ist so schonmal sehr gut ! + Multi-Zitat Zitieren
#4 23. November 2006 AW: SuSe 10.1 Prob mit Intel WLAN 3945ABG Hatte das noch irgendwo im Bookmark. Immer gerne! onlinepilot + Multi-Zitat Zitieren